Code-3 SuperVisor with TriCore for 2011 Charger Instrukcja Użytkownika Pobierz pdf (Strona 4)

Caution: Drilling into the housing of the light bar could damage wiring or other internal components.

FIGURE 10 FIGURE 11-PASSENGER SIDE SHOWN FIGURE 12

FIGURE 13 FIGURE 14 FIGURE 15

FIGURE 7 FIGURE 8 FIGURE 9

FIGURE 16

Installation and Mounting Instructions: Cont.

Wiring Instructions

Finish routing the cable as desired. It is advisable to leave an extra loop of cable when installing the light bar to allow for future

changes or reinstallations. Connect the black lead to a solid frame ground (earth), preferably the (-) or ground (earth) side of the

battery, and the power wire to the +12V terminal of the battery. Connect the remaining wires as shown on page 5.

WARNING: This unit must be mounted within the interior passenger compart-

ment of the vehicle only. It is not intended for use in exterior applications. All

devices should be mounted in accordance with the manufacturer’s instructions

and securely fastened to vehicle elements of sufcient strength to withstand the

forces applied to the device.

Driver and/or passenger air bags (SRS) will affect the way equipment should be

mounted. This device should be mounted by permanent installation and within

the zones specied by the vehicle manufacturer, if any. Any device mounted in

the deployment area of an air bag will damage or reduce the effectiveness of the

air bag and may damage or dislodge the device. Installer must be sure that this

device, its mounting hardware and electrical supply wiring does not interfere

with the air bag or the SRS wiring or sensors. Mounting the unit inside the ve-

hicle by a method other than permanent installation is not recommended as unit

may become dislodged during swerving, sudden braking or collision. Failure to

follow instructions can result in personal injury.

1 2 3 4 5 6 7 8

Brak uwag

Code-3 SuperVisor with TriCore for 2011 Charger Instrukcja Użytkownika Strona 4