Code-3 SuperVisor with TriCore for 2011 Caprice Instrukcja Użytkownika Pobierz pdf (Strona 4)

Installation Instructions Cont.

ANGLED

IN THE SLOT

DRILL HOLES

AT THESE

LOCATIONS

NOT CENTERED

IN THE SLOT

WRONG WRONG

CORRECT

FIGURE 1 FIGURE 2 FIGURE 3

FIGURE 4 FIGURE 5 FIGURE 6

FIGURE 7

Step-9 While making sure the SuperVisor is centered in the vehicle tighten all of the Black Oxided #8 X 1" Phillips Truss Head Sheet

Metal Screws (see Figures 17, 18, and 19). Tighten each of the screws a little at a time so that they are all tightened somewhat simultane-

ously, this will help keep the SuperVisor centered.

Step-10 While pushing the SuperVisor very tightly up against the headliner, tighten the (2) 1/4"-20 Inner Mounting Bracket screws as

shown in Figure 23 then tighten the (2) 1/4"-20 Outer Mounting Bracket screws as shown in Figure 24. The idea is to slightly crush the

SuperVisor's Sheet Metal Headliner Flange into the vehicle's headliner fabric to prevent light from ashing through into the Driver's eyes.

Note: It is best to have an assistant push up on the SuperVisor while you tighten each of the the screws to assure that it is tight

against the vehicle's headliner.

Step-11 Tighten the Vehicle's Driver and Passenger Side #8 Torx outer pivot bracket mounting screws as shown in Figures 25 and 26.

Step-12 Route the SuperVisor's Cable as desired.

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

Code-3 SuperVisor with TriCore for 2011 Caprice Instrukcja Użytkownika Strona 4