Code-3 DashLaser Instrukcja Użytkownika Pobierz pdf (Strona 11)

Troubleshooting

PROBLEM

CAUSE

REMEDY

Light is not lit and the reflector is No power at lighter plug Check ignition and fuse. Try

not turning another vehicle

Damaged or defective cordset Repair or return to P.S.E.

Reflector is turning but the light Lamp is burned out Replace lamp.

is not lit Missing or loose lamp clip Replace lamp clip

Defective wiring to the motor Repair or return to P.S.E.

The light is lit but reflector is not Rotating assembly is jammed Remove obstruction or return to

turning P.S.E.

Defective wiring to the motor Repair or return to P.S.E.

Defective motor Replace or return to P.S.E.

Light is not bright and reflector Low Voltage Try in another vehicle. Repair or

turns slow - less than 70 RPM replace bad socket or wiring

Light is bright but reflector turns Bearing oiled by user Thoroughly clean and don't re-oil

slow - less than 70 RPM Dirty or defective gears or bearings Clean or return to P.S.E.

Noisy operation Gears not worn in Let run for 1-2 hours, some noise

is normal

Blows fuses Defective cigarette lighter socket Try in another vehicle

Replaced lamp with wrong type Use only 55 watt H-1 lamps

Damaged cord or wiring in Dash- Repair or return to P.S.E.

Laser

Reversed polarity on a permanent See Permanent mounting section

installation.

Adhesive mounting will not stick to (see " Interior Mounting" section Use new adhesive pad

the surface on page 4)

Dome screw will not snug up Stripped or cracked screw boss Replace screw with #6x1/2" sheet

metal screw or replace dome

Magnet does not hold well Debris Clean magnet

Wax Remove excess wax

Uneven surfaces Use permanent mount

1 2 ... 6 7 8 9 10 11 12

Brak uwag

Code-3 DashLaser Instrukcja Użytkownika Strona 11