Code-3 21TR Plus MC Instrukcja Użytkownika Pobierz pdf (Strona 2)

Warning Signal Modules:

Selecting Flash Patterns:

There are seven possible 3-Level modes of operation (see Table 1). These modes are activated by combinations of the

L1 (GRN/BLK), L2 (WHT/BLK) and L3 (RED/BLK) wires. For example a standard progressive switch will use the Level-1

(L1), Level-2 (L1 + L2) and Level-3 (L1 + L2 + L3) modes. When using individual switches, make sure to select patterns

for all possible switch combinations. Each of the 3-Level modes of operation can individually ﬂ ash up to 10 pairs of

lightheads. Each pair of lightheads is programmed with a different wire in the 16 conductor cable (see Table 2).

NOTE: The 951 Series Software can operate a light bar with Multi-Color lightheads in three zones (Rear, Front

or Corners). If any of the lightheads in a zone are Multi-Color, then that entire zone is considered a Multi-Color

Zone and all 49 ﬂ ash patterns will be available. If there are no Multi-Color lightheads in a zone, then that zone is

considered a Single Color Zone and only ﬂ ash patterns 1 through 13 will be available.

In addition, if the lightbar contains Multi-Color takedown or alley lightheads, these heads can be programmed

with the same 49 ﬂ ash patterns as the other Multi-Color lightheads. If the lightbar contains Single Color

takedown or alley lightheads, these heads can be programmed with ﬂ ash patterns 1 through 13.

The ﬂ ash patterns are divided into four groups. The ﬁ rst group is the ‘Standard Flash Patterns’ and is available

in both Multi-Color and Single Color Zones (1 through 13). The next three groups are only available to zones

that are conﬁ gured as Multi-Color Zones. The second group is the ‘Primary Only Patterns’ (14 through 25). The

third group is the ‘Secondary Only Patterns’ (26 through 37). The last group is ‘Primary to the Driver’s Side and

Secondary to the Passenger’s Side Patterns’ (38 through 49). Primary and Secondary refer to the two colors that

are in a Multi-Color lighthead. See Table 3 to determine which color is considered Primary or Secondary in each

type of lighthead.

The ﬂ ash patterns in the ﬁ rst group (1 through 13) will automatically adjust to operate the lightheads for the

Multi-Color and Single Color zones. It is possible to have Multi-Color and Single Color lightheads in the same

zone. If the light bar is conﬁ gured this way, then please note that all ﬂ ash patterns will be available to the Single

Color lightheads, but these lightheads may not ﬂ ash in an effective way in all ﬂ ash patterns. The best ﬂ ash

patterns to use for a Single Color lighthead in a Multi-Color zone are the ‘Primary Only Patterns’ (14 through 25).

STEP 1:

Power-up the light bar. Select the desired 3-Level mode to program by applying +power to the appropriate wire in the 16

conductor cable (see Table 1).

STEP 2:

Continue applying +power to the wire(s) from Step 1. Enter Pattern Selection Mode by applying +power to the BLK/RED

wire in the 16 conductor cable.

NOTE: The BLK/RED wire must be connected to +power during Pattern Selection Mode and must be removed

from +power when pattern selection is completed. Failure to remove the BLK/RED wire from +power will effect

the normal operation of the light bar.

STEP 3:

Continue applying power to the BLK/RED wire and the wire(s) from Step 1. Refer to Table 5A and Table 5B for the

available ﬂ ash patterns.

To increment to the next pattern, momentarily hold the appropriate pattern selection wire (see Table 2) to +power for less

than two seconds and then release. The four corner light heads will turn on steady to indicate that the pattern has been

incremented.

To decrement to the previous pattern, momentarily hold the appropriate pattern selection wire (see Table 2) to +power for

two to four seconds and then release. The four corner light heads will turn on steady and then turn off to indicate that the

pattern has been decremented.

After the pattern selection wire has been released, the new pattern will begin to ﬂ ash and is automatically stored each

time. Repeat this step for each pair of heads using the appropriate pattern selection wire (see Table 2).

NOTE: To restore the Factory Default Emergency Warning Flash Pattern to any pair of lightheads, hold the

appropriate pattern selection wire to +power for more than four seconds. The four corner light heads will turn

on steady, turn off and then turn on steady again to indicate that the Factory Default Emergency Warning Flash

Pattern has been restored. The factory defaults for a progressive switch application (Level-1, Level-2 and

Level-3) are identiﬁ ed in Table 4.

STEP 4:

Repeat steps 1 through 3 for each of the seven possible 3-Level modes as desired.

1 2 3 4 5 6 7 ... 11 12

Komentarze do niniejszej Instrukcji

Brak uwag

Acura 2007 RDX User Manual (156 pages)

Brand: Acura | Category: Cars | Size: 6.70 MB |

2007 RDX

Table of Contents

Introduction

User Agreement

Getting Started

"AUDIO"

(pg. 142-144)

Entering a Destination

Driving to Your Destination

Information Features

System Set-up

100

System Initialization

109

System Limitations

111

Database Limitations

113

Customer Assistance

114

PC card slot

116

Coverage Areas

117

Frequently Asked Questions

127

Troubleshooting

135

Glossary

136

Voice Command Index

139

150 Navigation System

151

Navigation System 151

152

152 Navigation System

153

...............144

154

License notice

155

Acura 2007 RDX User Manual (3 pages)

Brand: Acura | Category: Cars | Size: 0.17 MB |

Table of Contents

More products and manuals for Cars Acura

Models	Document Type
2011 TL	User Manual Acura 2011 TL User Manual, 614 pages
2003 CL	User Manual Acura 2003 CL User Manual, 1 pages
2010 TSX	User Manual Acura 2010 TSX User Manual, 524 pages
1992 Integra	User Manual Acura 1992 Integra User Manual, 1 pages
2009 TSX	User Manual Acura 2009 TSX User Manual, 526 pages
1993 Legend Sedan	User Manual Acura 1993 Legend Sedan User Manual, 1 pages
2003 RSX	User Manual Acura 2003 RSX User Manual, 1 pages
2006 RSX	User Manual Acura 2006 RSX User Manual, 1 pages
2006 MDX	User Manual Acura 2006 MDX User Manual, 1 pages
2001 3.2 TL	User Manual Acura 2001 3.2 TL User Manual, 1 pages
2008 TL	User Manual Acura 2008 TL User Manual, 152 pages
2004 3.5 RL	User Manual Acura 2004 3.5 RL User Manual, 1 pages
1991 Integra Hatchback	User Manual Acura 1991 Integra Hatchback User Manual, 1 pages
2002 RSX	User Manual Acura 2002 RSX User Manual, 1 pages
1997 Integra Hatchback	User Manual Acura 1997 Integra Hatchback User Manual, 1 pages
1995 Legend Coupe	User Manual Acura 1995 Legend Coupe User Manual, 1 pages
2004 MDX	User Manual Acura 2004 MDX User Manual, 1 pages
2010 RL	User Manual Acura 2010 RL User Manual, 551 pages
2002 TL	User Manual Acura 2002 TL User Manual, 1 pages
1990 Legend Sedan	User Manual Acura 1990 Legend Sedan User Manual, 1 pages